Crash, Bang – What was that!

Last night was my last night on Inspiration until next spring.  There was a North wind and the temperature was 35 degrees F.  In the morning the frost on the boat was very heavy.  I awoke about 6:40 AM, ate breakfast and put everything on the dock that I wanted to take home this trip.  The truck & trailer with my new 16.5 kayak was stored in the heated building so it was nice to put the things away in the vehicle.

The Saqugatuck Marine people arrived at o730 and we started.  By 1100 hrs it was out and ready for power washing.  I use VC17 so the washing was a snap and the moved it into the heated storage building to a temporary position.

As they were removing the dolly’s and putting the corner boxes there was a very loud bang and one of the wood supports for my cradle broke.  Luckily there was a box under both corners and no trauma resulted.  However, where do you find a 2″x6″x14′ solid oak board to replace the broken one?  I called around and located a rough cut 2×12x14′ board we can rip into two pieces.  Now I have to get up early and run to Charlotte, MI buy the lumber and then deliver it to the marina.  I figure this is cheaper than the solution that they would come up with.  The board is $62 ripped so the price is not too bad per board ft (about $0.50 per bd ft).  The high $ item will be gasoline running around and labor to install the board as it is inside one of their facilities and employees have to do the work at $75 per hour.

I’ll let you know tomorrow what transpires.  Oh yes,  I have to stop by the local hardware and get new bolts, nuts , washers and some 2′ all thread 1/2″ rod (in case we have to make a custom something).